| 1 person marked this as a favorite. |
Hey all, I love the new box, but one problem is that the cards tend to fall over and slide down to the bottom, which makes them nearly impossible to pick up. Additionally when you remove all of the cards from a section, it's hard to tell which divider is which since they're stuck together.
Has anyone come up with a solution for this? I was thinking of adding some sort of spacer between the dividers so they don't become stuck together, but I'm not sure what to use, and I'm also not sure how to prevent the card slippage. Any ideas?
| 1 person marked this as a favorite. |
I used the foam blocks that came with the Core Set. They reduce the free space into which cards/dividers might slip, and they can be adjusted based on the space requirements of whatever AP might be added. Additional foam can be added (though it might not fit quite as snugly) to create similar spacers. A handy source of foam for most gamers can be found in foam miniature storage trays.
I'm using the foam blocks as well but attempting to cut them into smaller blocks has resulted in some very ugly failures.
I wish the dividers stood up on their own and didn't need to lean against something. Or, that I had, like, thin slices of foam that the dividers could lean against.