|
I didn't really know where to put this, and this seemed like as good a place as any.
I just got a set of Writhing Stranglers. Whenever I get new Pewter Minis, I always remove any bits of excess pewter. Then I got to 2 thick ones in exactly the same spots on every miniature. They're between the hands and the legs. They're about as thick as the legs, so I'm worried that I might break the legs off if I remove them.
So, finally, my question: Should I remove them, and if so, how should I go about it?
I didn't think writhing stranglers had hands or legs.
Should I remove them, and if so, how should I go about it?
Well, first off: are you sure that this is flash (the term for excess pewter/plastic hanging off of a part)? It could be meant to be a worm. I don't have my stranglers on-hand right now, so I can't look for myself.
As to removal, if necessary, an exact-o knife should do the trick if you are careful. Just take your time doing it. Wire or gate clippers might also work, if you can get them to the target area easily.
Hope this helps,
TK
|
|
Should I remove them, and if so, how should I go about it?Well, first off: are you sure that this is flash (the term for excess pewter/plastic hanging off of a part)? It could be meant to be a worm. I don't have my stranglers on-hand right now, so I can't look for myself.
As to removal, if necessary, an exact-o knife should do the trick if you are careful. Just take your time doing it. Wire or gate clippers might also work, if you can get them to the target area easily.
Hope this helps,
TK
Thanks for the Advice! When I set thim on the table, I'll be sure to give you credit.